Parts

[tmmiibaja]

More to come, cleaning out some of the stuff I have accumulated over the many engine builds.......

SBC raw water pump setup with both brackets and low-rev (under 5400) pulley, brackets black, pulley red

SBC Chevrolet valve covers less than an hour of run time, black crinkle finish with red Chevrolet, will fit roller rockers and SM exhaust.

SBC PS pump, Alternator, crank pulley, brackets, all brackets powdercoated black, pulleys red, V belt setup.

SBC MEFI 3 EFI system, currently tuned for a mild 350 in the 320hp range, includes cap, rotor, intake, fuel rails, wiring harness, ECU, fuel pump, air filter, throttle body and all sensors.

Make offer, tons and tons more to come.

[johnnyexcal]

p.m. sent - need pics of valve covers - perimeter bolt or center bolt? -

[tmmiibaja]

Center bolt, trying to get some this week.

[FormulaMatt]

post some pics...I may take the

SBC PS pump, Alternator, crank pulley, brackets, all brackets powdercoated black, pulleys red, V belt setup

How much?

[SKRAMER]

Post pics..

[FormulaMatt]

post pics. Prices would be awesome too!

[tmmiibaja]

Been busy, here are some pictures.



pulleys and brackets powdercoated, everything was fine when removed, went with a serpentine setup. $200


Imco puke tank with brackets, $60.



Serp. sea water pump, no housing or impeller, pulley has a chip in it, $100.



sbc crossover, no by pass the thermostat housing was $91 dealer when I bought it, asking 120 for everything.


v belt sea water pump, with small block brackets, has ~40 hours of run time, was fine when removed, was replaced with a serp belt pump. Asking $450.

Everything is on the north end of Columbus, Ohio, will ship at buyers expense. Have an offer in on a house, would like to move less stuff and free up a couple bucks.