rectangle port heads, aluminum intakes, other stuff..

[Full Force]

I have 2 sets of heads here, from my engines, one set with approx 120 hrs, other is 4-500 hrs, both run fine. These were on a running driving boat.

Open 118cc
I: 2.19"
E: 1.88"
325 CC runner.

625.00 a set, pick up preffered, can ship at buyers expense.

http://i36.photobucket.com/albums/e41/86lxmustang/108_5455.jpg


http://i36.photobucket.com/albums/e41/86lxmustang/108_5456.jpg


http://i36.photobucket.com/albums/e41/86lxmustang/108_5458.jpg

I also have 2 aluminum intakes, they are like a Edelbrock performer series, they are GM, standard is Q-jet but they have Holley adapters now, all included, you can runeither on them, 100.00 each + shipping

http://i36.photobucket.com/albums/e41/86lxmustang/108_5461.jpg

http://i36.photobucket.com/albums/e41/86lxmustang/108_5460.jpg

One cast 454 crank left, 50.00

stock 3/8 rods with 330 cast pistons, 40.00 a set of 8

one set of roller tip rockers, I think 1.7 ratio I will check, not full roller, 75.00